Warming Drawer Model WD24, WD27 and WD30 Care and Use Manual
TABLE OF CONTENTS Model and Parts Identification ............................................................................. 3 Important Safety Practices .................................................................................... 3 Controls and Operation ......................................................................................... 4 Operations ............................................................................................................... 5 Temperature Selection Chart .
MODEL and PARTS IDENTIFICATION 2 3 1 4 5 6 7 8 Packaged Inside Drawer: • Reversible Rack • 2 Mounting Brackets and Screws • Literature Packet (Care & Use, Installation Instructions, Registration Form) Parts Key: 1. Data Plate 2. Moist•Dry Selector 3. Stainless Steel Drawer Interior 4. Gasket 5. Rail Lock 6. Thermostat Dial 7. ON Light Lens 8.
CONTROLS REVERSIBLE RACK The warming drawer will keep hot, cooked foods at serving temperature. Always start with hot food. DO NOT use to heat cold food other than proofing yeast dough, crisping crackers, chips, and dry cereal, or warming dishes or plates. THERMOSTAT DIAL / ON KNOB ➝ L ED ➝ Dial O OFF Low Rack Position HI Indicator • Low position raises utensil about 1/2" from drawer bottom. Example: Used when proofing yeast dough or when a utensil cannot be placed directly on a hot drawer.
OPERATIONS DO NOT LINE DRAWER WITH ALUMINUM FOIL. TO USE: • Turn thermostat dial to a temperature setting: LO ➟ ➟ ➟ ➟ MED ➟ ➟ ➟ ➟ HI. • Slide knob to select a Moist or Dry setting. • Allow time for the drawer to be preheated: LO 15 minutes MED 25 minutes HI 35 minutes • Preheat with rack in place if using that arrangement. • Preheat empty serving dish while preheating drawer. • Add cooked, hot food in cooking utensil or to heat-safe serving dishes.
CARE AND CLEANING TO REMOVE THE DRAWER TO REPLACE THE DRAWER • Pull drawer to fully open position • • Lift up on left side Release Lever and press down on the right side Release Lever. Be sure Cabinet Rails are pushed inside cabinet. • Align each Drawer Rail to each Inner Cabinet Slide. Use the Slide Lock to guide placement. • Close the drawer completely; the Slide Lock will secure the drawer. • Pull out drawer fully to check that both locks are engaged.
CARE AND CLEANING CLEANING CHART Area / Material Cleaning Products Directions Drawer/ Polished Stainless Steel Hard Water Spots and Scale: vinegar. Apply with sponge or cloth, then Rinse with clear water and wipe dry. Satisfactory for use on all finishes. Drawer Front Frame/Brushed Stainless Steel Mild Cleaners and Polishes: Soap, ammonia, or detergent and water. Stainless Steel Magic®, or Shimmer® Swab or wipe with cloth. Rinse with water and dry. Satisfactory for use on stainless finishes.
WARRANTY – WD24, WD27 and WD30 FULL ONE YEAR WARRANTY Covers one year from date of Installation, or date of occupancy on a new or previously unoccupied dwelling. Save your dated receipt or other evidence of installation/occupancy date. Thermador Will Pay For: All repair labor and replacement parts found to be defective due to materials and workmanship. Service must be provided by a Factory Authorized Service Agency, during normal working hours. For a Service Agency nearest you, please call 800/735-4328.
