Installation Guide

Page 8
1 Parts Bag containing:
2 - Screws,
1/4-20 x .50
(12.7mm) Hex
Head
2 - Screws, #8-18
x .375 (9.5mm)
Phillips
8 - Wood Screws, #10
x .50 (12.7mm) Phillips
Round Head
2 - End Cap Trim
1 - Plastic
installation
template
(see pg. 14)
1 - Electrical Panel
2 - 2 in. (51mm)
Support Legs
2 - 4 in. (102mm)
Support Legs
2 - Upper Support Brackets
INSTALLATION
MANUAL
MASTERPIECE
®
SERIES DOWNDRAFT VENTIL
A
TOR
VENTILA
TEURS ENCASTRÉS SÉRIE MASTERPIECE
MD
VENTILADOR DE
TIRO DESCENDENTE SERIE MASTERPIECE
®
MANUEL
D'INSTALLA
TION
MANUAL DE
INSTALACIÓN
Installation
instructions
U
SE
AND CARE
GU
IDE
GUÍA
DE USO Y CUIDADO
MASTERPIECE
®
SERIES DOWNDRAFT VENTILATOR
GUIDE
D'
UTILISATION
ET D'ENTR ETIE N
VENTILA
TEURS ENCASTRÉS SÉRIE MASTERPIECE
MD
VENTILADOR DE
TIRO DESCENDENTE SERIE MASTERPIECE
®
Use and Care guide
Wiring diagram
Downdraft Ventilator Housing
BEFORE YOU BEGIN
Installation review
This downdraft system can be used to exhaust cooking by-products
such as heat, steam, and smoke that may be created while cooking
using gas or electric cooktops. With its versatile design, there are ve
(5) basic discharge options - left, right, rear, front and recirculation. It
is important to rst plan your installation. The purchase of additional
accessories to complete the installation may be necessary.
It can be mounted in an island, peninsula, or conventional wall location.
The blower (purchase separately) and electrical panel can be mounted to
the downdraft unit, inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic steps:
•
Plan the installation.
•
Cut out the countertop opening.
•
Prepare the downdraft housing.
•
Cut out the cabinet opening for discharge.
•
Mount the downdraft in the cabinet.
•
Install gas cooktop seal kit accessory, if applicable.
•
Connect the ductwork and install the blower.
•
Install downdraft electrical panel, if in remote location.
•
Install the cooking appliance.
•
Install end caps to downdraft.
•
Check the operation.
Note: the high level of air ow of this appliance may effect the gas
ame on some types of gas cooktops. This is NORMAL and will cause
no harm, but can be corrected by lowering the speed of the blower.
Parts supplied
Tools needed
•
Measuring tape
•
Pencil
•
Phillips screwdriver #2
•
Nut drivers - 11/32” (8.7mm), 3/8” (9.5mm), 7/16” (11.1mm)
•
Box-end wrench
•
Spirit-level
•
Aluminum tape (DO NOT use insulating tape)
•
Saw
•
Tin snips
•
Work gloves