Installation Guide

Page 17
3. Check that markings in cabinet line up with ducting coming
from downdraft.
4. Remove downdraft housing from cabinet.
CAUTION
Before cutting hole in cabinet for ductwork, check for interference
with oor joists, wall studs, electrical wiring or plumbing.
5. Cut ductwork hole in cabinet - as well as holes in wall or oor a necessary.
Mount downdraft in cabinet
1. Set downdraft into cabinet/countertop opening as far back as possible
and make sure it is level.
(2) #10 X 0.500
(12.7mm)
WOOD SCREW
HEX
SCREW
SUPPORT
LEG
2. Extend support legs and attach to bottom of cabinet with (2) screws
through each leg. Tighten hex screws.
If cabinet bottom is removed: Use blocks as spacers between oor and
support legs.
(2) #10 X 0.500 (12.7mm)
WOOD SCREWS
UPPER
SUPPORT
BRACKET
3. Extend upper support brackets and attach to sides of cabinet with (2)
screws through each bracket.
Installations using exible blower only:
4. Extend blower support legs and secure them to bottom of cabinet with
a screw through each bracket. Tighten (4) bolts to secure legs to ex
blower.
(4)
BOLTS
FLEXIBLE
BLOWER
INSTALLATION