Specification Sheet

These warranties give you specific legal rights and you may have other rights that vary from state to state. Limited warranty from date of purchase. For complete warranty details, refer to your
Use & Care manual, or ask your dealer.
Specifications are for planning purposes only. Refer to installation instructions and consult your countertop supplier prior to making counter opening. Consult with a heating and ventilation
engineer for your specific ventilation requirements. For the most detailed information, refer to installation instructions accompanying product or write to Thermador indicating the model
number. Specifications are correct at time of printing. Thermador reserves the right to change product specifications or design without notice. Some models are certified for use in Canada.
Thermador is not responsible for products that are transported from the U.S. for use in Canada.
1 800 735 4328 | USA THERMADOR.COM | CANADA THERMADOR.CA | ©2021 BSH HOME APPLIANCES CORPORATION. ALL RIGHTS RESERVED.
10 / 21
Page 6 of 6
PRD305WHU
30-INCH DUAL-FUEL PRO HARMONY
®
RANGE
PROFESSIONAL SERIES, STANDARD-DEPTH, PORCELAIN COOKTOP SURFACE
30-INCH RANGE DIMENSIONS AND SIDE CLEARANCE REQUIREMENTS
as defined in the “National Fuel Gas Code” (ANSI Z223.1, Current Edition).
Clearances from non-combustible materials are not part of the ANSI Z21.1
scope and are not certified by CSA.
Combustible
Materials
28" (711 mm)
27¼" (692 mm)
36
"
(914 mm)
m
in.
to
combustible
materials
24" (610 mm)
max. recess depth
Combustible
Back Wall
35 ⅞ " (911 mm) Min.
36 ¾" (933 mm) Max.
22⅝" (575 mm)
44⅞" (1140 mm)
Total Clearance
Installation Side Clearances
Zero Clearance Wall and
Island Trim
24⅝" (625 mm)
24¾" (629 mm)
NOTE: A 36-inch
minimum clearance is
required between the top
of the cooking surface
and the bottom of an
unprotected cabinet. A
30-inch clearance can be
used when the bottom
of the wood or metal
cabinet is protected by
not less than
11
/
44
inch of a
ame retardant material
covered with not less
than No. 28 MSG sheet
steel, 0.015 inch (0.4 mm)
thick stainless steel, 0.024
inch (0.6 mm) aluminum,
or 0.020 inch (0.5 mm)
thick copper.