Installation instructions

11
A minimum height clearance of 8-3/8'' (212 mm) is needed
above the hood for transition mounting.
2. Depending on direction of discharge, align mounting
holes at base of transition with the mounting holes of
the ½'' (13 mm) flange located at the top or rear of
the hood.
3. Fasten transition to hood using four (4) 1/4'' (6 mm)
sheet metal screws included with hood.
Note: Screws must not hinder damper operation.
4. Seal connection between transition and hood with
aluminum tape. DO NOT use duct tape. Ensure that
the connection is completely sealed.
5. Remove tape holding damper closed.
Wall mount installation
9 CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Wood hanging bracket
1. The installation height ranges from a minimum height
of 30'' (762 mm) to a maximum height of 40''
(1,016 mm); however, it is necessary to follow the
cooking appliance manufacturer’s installation
instructions for proper hood height. (See “Clearances
and requirements” on page 6.)
2. After the hood installation height has been
determined, draw a horizontal line at a distance above
the cooktop equal to the recommended hood
installation height plus 16½'' (419 mm). This line is the
mounting location of the wood support bracket
shipped with the hood.
3. Find the centerline of the hood. Draw a vertical line
along this centerline up to the horizontal line drawn in
Step 2.
4. The hood is mounted to the wall using the wood
support bracket shipped with the hood. Remove the
wood support bracket located at the top side of the
hood by removing the two shipping screws. Mark the
center line of the wood bracket.
5. Locate a stud on both sides of the hood centerline to
use for mounting the wood support bracket.
6. Align the top of the wood bracket along the
horizontal line drawn in Step 2. Align the centerlines
of the bracket and cooktop.
7. Drill a 3'' (76 mm) deep 3/16'' (3 mm) tap hole through
the wood support bracket, wall, and into the stud.
8. Use three, 3'' (76 mm) screws to attach the bracket to
the wall. For support of the hood, use three studs.
Countersink the screw heads to prevent interference
with the hood.
*Follow cooking appliance manufacturer’s
recommendations.
*30" (762) –
40" (1016)
16½"
(419)
16½"
(419)
16½"
(419)
inches (mm)