Installation instructions

10
Blower options
25 ft. remote and in-line blower extension cable
The 25 ft. remote and in-line blower extension cable
(EXTNCB25W) is available to connect the hood to the in-
line and remote blowers for distances up to 25 ft. The
accessory cable must be purchased separately. DO NOT
use more than one extension cable per installation.
Attaching the hood transition
Discharge direction
The hood can be mounted on a wall or suspended from a
cabinet. Both vertical and horizontal discharge are
possible with either mounting method.
Vertical discharge transition
The hood is shipped ready for vertical discharge.
The transition supplied with the hood connects to
standard 10-inch round duct. The figure shows the
transition connected for vertical discharge.
Horizontal discharge transition
The transition supplied with the hood connects to
standard 10-inch round duct. The figure shows the
transition connected for horizontal discharge.
1. To change to horizontal discharge, move the
discharge cover to the top of the hood. Use a 3/8'' nut
driver to remove the (4) 3/8'' hex nuts from the plate.
Assembly of the transition
Hoods are supplied with a 10" (254 mm) round transition.
A locally supplied transition is required for other sizes.
The supplied transition mounts to the top or rear of the
hood, depending on the discharge direction.
Description SKU
Remote blower (mounted to roof or external
wall)
VTR1FZ
VTR2FZ
In-line blower (mounted between kitchen and
external wall)
VTI1FZ
VTI2FZ
Integrated blower (mounted inside the hood) VTN1DZ
VTN2FZ
18"
(457)
6"
(152)
8⅜"
(212)
8⅜"
(212)
8⅜"
(212)
inches (mm)
10"
(255)
8 ⅜ "
(212)
8 ⅜ "
(212)
8 ⅜ "
(212)
inches (mm)
26⅜"
(669)
26⅜"
(669)
26⅜"
(669)
18"
(457)
18"
(457)
18"
(457)
8
⅜"
(212)
8⅜"
(212)
8⅜"
(212)
inches (mm)