Installation instructions

Table Of Contents

Common ducting configurations

NOTE: The figure does not represent all configurations or

installation methods. The image is to be used as a guide

ONLY.

Choosing the correct blower

All blower models are sold separately. It is recommended

to use only Thermador blowers with Thermador Pro

ventilation hoods. See the “Ventilation Planning Guide”

for recommended blowers. Contact Customer Service for

additional options (see the back page for contact

information).

Integral, in-line and remote blowers are available through

your authorized Thermador

dealer. For local dealer

information, visit the Find a Dealer section of our website

at www.thermador.com.

The blower performance options will vary in cubic feet per

minute (CFM) and is dictated by the cooking surface, the

volume of air that needs to be moved and the length of

the duct run. For long duct runs with multiple turns and

bends, consider using a more powerful blower. For the

most efficient air-ﬂow exhaust, use a straight run or as few

elbows as possible (refer to “Ductwork Preparation”).

Back-draft

damper on

transition

Back-draft

damper on

transition

Back-draft

damper on

transition

Integral blower

In-line blower

Remote

blower

Remote blower

30" (762) –

40" (1,016)

18"

(457)

Varies

inches (mm)