Owners Manual

English 4
Operation
Hood Control Panel
OFF
Pressing the button once turns ventilator off and resets the
control.
LO | MED | HI (Fan Speed)
Pressing the button once, from an “off” state, turns the
ventilator on. The LEDs above the buttons indicate the
current fan speed. When the fan is on, the corresponding
LED is illuminated.
LO — Low
MED — Medium
HI — High
AUTO (Heat Sensing Feature)
When in AUTO mode, the hood automatically turns the
blower on, depending on the amount of heat the control
senses. It automatically adjusts every 5 minutes. If the
control does not sense a high level of heat, it will turn the
blower off.
FILTERS (Clean Filter Reminder)
After 40 hours of operation, the LED above the FILTERS
button will illuminate indicating that the filters need to be
cleaned. When this indicator illuminates, clean the filters as
instructed on page 6. After cleaning, press and hold the
FILTERS button for 3 seconds to reset the 40-hour period
and to turn the LED off.
DELAY (Shut off)
If the blower is off when the Delay button is pressed, the
blower will turn on to the HIGH speed setting for 10
minutes. At the end of the cycle the blower will turn off.
If the blower is on when the Delay button is pressed, the
blower runs for 10 minutes at the current speed then turns
off.
During the 10 minute timed period, the LED above the
Delay button is illuminated.
To interrupt a timed period, press one of the Fan Speed
buttons or OFF button.
LIGHTS (Halogen Light Control)
This button controls the halogen lighting. The first press
turns the lights on. A second press dims the lights. A third
press turns the lights off.
Figure 1: Control Panel