Installation Guide

Page. 5
Advance planning
Before you begin
9 CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
Parts included
• Metal transition with backdraft damper
• Stainless steel baffle filters
• Stainless steel grease trays
• Blower adapter
• Wood support bracket used as hood mounting
bracket (part of install- DO NOT THROW AWAY)
• Literature packet with fastener assortment*
* Hardware provided is for mounting through standard
thickness drywall or plaster into wood studs. Installers are
responsible to provide hardware for other types of
mounting situations.
Tools and parts needed
• Blower (refer to the Ventilation Planning Guide for
compatible blowers)
• Ducting as needed (refer to “Equivalent duct lengths
for commonly used transitions” table)
• Aluminum tape (DO NOT use duct tape.)
• 1/2'' (13 mm) conduit if required (follow local codes)
• 1'' (25.4 mm) strain relief
• Phillips screwdriver
• T-20 torx head screwdriver
• 11/32'' nut driver or socket and ratchet
• Drill with 3/16'' (4.76 mm) drill bit
• Wire stripper
• Tape measure
• Protective work gloves
IMPORTANT: DO NOT throw away any packaging until
appliance is fully installed.
Optional accessories available for
separate purchase
Refer to www.thermador.com for more details.
Accessories Description
EXTNCB25W 25 ft. remote and in-line blower
extension cable
EXTNSET4 25 ft. remote and in-line blower
extension cable adapter kit
CHMHP**W 6'' tall duct cover
CHMHP**TW 18-35'' tall telescoping duct cover
CHMHP**XTW 42-59'' extended telescoping duct
cover
WC8 8'' wall cap
WC10 10'' wall cap
RFPLT600P Roof plate for use with 600 CFM
remote blower VTR630
RFPLT1000P For use with 1000 CFM remote
blower VTR1030 and 1300 CFM
blower VTR1330
REMCPW Remote control panel