Installation Guide

Installation Instructions English | 15 |

7. Install the structure to the horizontal support (previously

attached to the ceiling) with 16 - 4.2 x 8 mm screws.

A. Upper horizontal support

B. 16 - 4.2x8 mm screws

Mounting the blower housing on the

structure

1. Slide the blower housing under the structure.

2. Attach the blower housing to the lower vertical supports

with 2 leveling screws.

3. Secure it with 16 installation screws. See the image

below.

Mounting the upper duct covers

1. Get together the upper duct covers and assembly them.

 Slide the edge of the duct cover under the clip

located in the opposite duct cover.

 Push them until you hear a click. The bulges on the

edge of the duct covers has to enter in the clip

slots.