Installation Guide

Installation Instructions English | 19 |
5. Carefully pull the top part of the extension upwards.
Screw the left and right sides of the extension to the
mounting bracket with the supplied stainless screws.
Recirculating Kit (optional)
When used in recirculation mode, To Reduce the Risk of
Fire and Shock use only conversion kit Model RECHDDB.
If it is not possible to vent cooking fumes and vapors to
the outside, the hood can be used in the non-vented
(recirculating) version, using the recirculating kit .
Fumes and vapors are recycled through the round grid.
See optional accessories section.
1. 
screws provided.
2. 
of the vent cover bracket installed earlier.
A
B
C
A. Vent cover bracket width

C. 3.5 x 9.5 mm screws
3. 
4- 3.5 x 9.5 screws provided.
A
B
A. Vent cover bracket
B. 3.5 x 9.5 mm screws
4. 
bottom of the hood outlet.
X
A
C
B
D
E

B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
5. Cut the duct to the measured size “X.”
6. 
7. 
8. 
exhaust outlet from the hood.
9. 
with the four assembly screws.
10. 
the exhaust outlet from the hood.