Instructions / Assembly

Care Instructions
• Turn off ThermaCELL Heated Insoles when not in use.
• Store the Insoles and Global Charger in a clean and dry place. Charge the Insoles
fully before long-term storage. Recharge the Insoles every few months to maintain
peak performance.
• Only use ThermaCELL chargers to charge the Insoles.
• Only charge the Insoles when they are outside of shoes or boots.
• Do not damage the heating elements by excessively bending the Insoles.
• Cut the Insoles to size only as indicted in instructions and on Insole.
• Clean with a damp cloth only. Do not use chemicals or cleaning agents.
• Do not submerge in water. Insoles are water resistant, not waterproof. If Insoles
become submerged in water, air dry before attempting to use.
• Only air-dry the Insoles. Do not place them on radiators or any other hot surface.
• Let the Insoles dry completely before charging again.
• The switch on the Heated Insoles must be set to the left (OFF) position when charging.
Important Information if Insoles are Not
Heating or Operating Correctly
Perform the following actions if the Insoles do not seem to be heating correctly:
1. Charge the Insoles completely then disconnect the charger.
2. Turn the Insoles on. The LED light on the back of each Insole should flash once every
few seconds. Using the Remote Control, press the High button. The LED light on each
Insole should now flash in groups of three every several seconds. If they LEDs do not
flash correctly, please refer to the Remote Control pairing instructions below.
3. Place the Insoles in a refrigerator for 5 – 10 minutes.
4. After taking the Insoles out of the refrigerator, check the LED lights on both Insoles.
The LED lights should still be flashing in groups of three every several seconds.
5. If the lights are flashing in groups of three, then the Insoles are in heating mode. Press
the Insoles to your hand or cheek and check for warmth. If you do not feel any heat,
please contact ThermaCELL Customer Service.
Remote Control Pairing Instructions
If the Remote Control does not properly activate the Insoles per the instructions, you will need
to re-key the Remote Control to the Insoles. The Heated Insoles and the Remote Control are
keyed at the factory so that your Remote Control will only operate your Insoles. Please follow
the directions below ONLY if you need to re-key Heated Insoles with a Remote Control:
1. Each Insole must be “paired” with your Remote and is easiest to do one Insole at a time.
2. Turn the Insole switch on the back of each Insole to the right (ON) position. Insert and
remove the charging cable twice (2 times) very quickly into the Recharge Port located
at the back of the Insole. Note: to ease the process, insert charger into Recharge Port
until Insole LED illuminates, you don't have to “click” it in.
3. The Insole LED will start flashing a sequence of one (1) long flash followed by four
(4) very short flashes to indicate the “pairing” mode is in process. The flash sequence
will repeat three (3) times and then will time out. During this process, press any button
located on the Remote (if you do not press a button in time, simply repeat the process
from Step 2). This will re-key the Insoles with the Remote Control.
4. Repeat Steps 2-3 with the other Insole.
5. This completes the re-keying of your Heated Insoles.
5–E