Instructions / Assembly

HOUSING FRONT
RUBBER SPACER
BATTERY
BATTERY
HOLDER
PUSH
BATTERY
OUT TO
REMOVE
HOUSING BACK CIRCUIT BOARD
Remote Control Battery Replacement
The Remote Control comes equipped with one Lithium Cell # CR2032. The battery should
last approximately two years under normal usage. However, to insure uninterrupted service
from the remote, replace the battery annually. To replace the battery:
1. Remove the four small Phillips screws on the underside of the Remote Control.
2. Lay both sides of the Remote Control open on a table (refer to the diagram
on page 4-E). Remove the green printed circuit board and turn the board over so
the battery holder is facing up. Using a coin, push the battery out from under the
battery holder.
3. Replace the battery by inserting the new battery back into the holder making certain
that the positive (+) side of the battery is facing up.
4. Return the green circuit board to its original position making certain the battery is
located on the underside of the printed circuit board. Now place the housing front
with the black rubber spacer piece over the circuit board.
5. With the two sides of the Remote Control together, secure the two side panels by
replacing the four small Phillips screws.
The Integrated Lithium-Ion Polymer Batteries
Embedded in the Insoles
The high-quality Lithium-Ion Polymer batteries can be fully recharged well over 500
times.
The batteries are embedded in the Insole material and cannot be accessed.
If Insoles are not used for an extended period of time, charge them completely before
next use.
Battery Disposal: Battery must be disposed of in accord with local laws and regulations.
4–E