Instructions / Assembly

3. Insert the Insoles into shoes or boots by following the directions located at the
bottom of the Insoles. Trim Insoles to fit if needed. Insert into shoes with the black
side facing down (red side up).
4. Use the Remote Control to operate the Insoles while shoes or boots are on feet. The
LED light on the remote will flash once to confirm a heat setting has been transmitted
to the Insole. Remote can be used up to 7 feet from Insoles.
Note: The heating element in each Insole extends from the toe area to the ball of the
feet. The arch and heel areas are not heated.
Two Ways to Turn Off the Insoles
Long-Term: When you are not using your Insoles for a prolonged period of time (many
hours or days), remove the Insoles from your shoes and turn the ON/OFF Switch at
the back of each Insole to the left (OFF) position. The Remote Control will turn off
automatically.
Short-Term: When you are not using your Insoles for a short period of time (up to a
few hours or when your feet are warm), use the Remote Control's “No Heat” setting
to put the Insoles into “standby” or “sleep” mode. This will exhaust the battery at
approximately 2% per hour. When heat is needed, simply press the High or Medium
button on the Remote Control to reactivate heat.
Helpful Hints for Using the Insoles
• Heated Insoles do not get “hot” to the touch, and will not get as hot as disposable/
chemical warming pads. They are engineered to keep your feet warm, to avoid
sweating and freezing. They maintain a steady temperature of 100° F (38° C) or
111° F (44° C) inside your boots or shoes (depending on the heat setting chosen),
keeping your feet around normal body temperature.
• For best results, use Heated Insoles in a cold environment with insulated boots. You
are less likely to feel the heat output in a warm environment outside of footwear.
• For a better fit, remove the insoles currently in your footwear (if removable), and
replace with Heated Insoles. Make sure footwear is not too tight; tightness naturally
causes feet to get cold.
• The tabs at the end of the Heated Insoles will assist in easy removal of the Insoles
from shoes or boots after use. Be sure to insert Insoles with the tab sticking up.
• Once Heated Insoles have been fully charged, they will operate for up to 5 hours on
Medium. The outside temperature and quality/insulation of footwear will affect run
time.
• To prolong battery life, it is recommended that the Insoles be in the No Heat setting
when the user is engaged in strenuous activities. At high exertion levels, the body
typically generates enough heat to keep the feet warm.
• Maintaining a comfortable heat level while using Heated Insoles depends upon
proper installation and activation of the Insoles, along with the type, fit, insulation,
and dryness of the footwear and/or socks being worn.
• For best performance, it is recommended to wear well insulated boots and medium-
to-lightweight socks that wick away moisture and keep feet dry. A very heavy sock
will prevent heat from reaching your foot.
• For best results, turn Heated Insoles on at the first sign of your feet getting cold.
3–E