Instructions / Assembly

Package Contents
The ThermaCELL Heated Insoles box contains two Heated Insoles, one Remote
Control, one Global Charger, one Lanyard, one Drawstring Travel Bag, and this
instruction booklet.
Trimming Insoles for Exact Fit
Insoles may be trimmed to fit shoes or boots if needed. If your footwear has a removable
insole, take it out and use it as a cutting guide. Be sure to follow the WARNING statement
printed on the bottom of the Insoles!
Caution: Do not cut beyond the solid line or excessively bend the Insoles. This will
cause damage to the heating elements and the product, and will void the warranty.
Charging and Recharging Insoles
ThermaCELL Heated Insoles must be fully charged before the first use. For best results,
charge Insoles at room temperature. It may take up to 4 hours to charge.
The ON/OFF switch and recharge port for the Insoles are located at the back of the heel
of each Insole. A black rubber flap protects the switch and recharge port.
Directions:
1. Set the ON/OFF switch on the back of each Insole to the left (OFF) position.
2. Plug the Global Charger into an electrical outlet. The LED on the inline connector will
not yet turn on.
3. Plug the Global Charger cables into each Insole Recharge Port located at the back of
each Insole. Once the connections are established, the charger LED light on the inline
connector will glow green indicating that the charging process has started.
4. Charge Insoles until the LED light on the inline connector turns off, indicating that the
Insoles are fully charged.
5. Unplug the Global Charger from the electrical outlet and remove the cables from each
Insole. The ThermaCELL Heated Insoles are now ready for use.
Note: You can charge one or both insoles at the same time. If either Insole needs to be
charged, the LED light on the inline connector will glow green when plugged into both
the wall and the Insole. When the insoles are fully charged, the green LED on the inline
connector will turn off.
To Activate the Insoles
The first time that you use your ThermaCELL Heated Insoles, you will have to remove the
clear plastic tab from the Remote Control to activate the already installed battery.
1. Turn each Heated Insole on by moving the ON/OFF switch at the back of each Insole
to the right (ON) position. The red LED light at the back of each Insole will flash
intermittently and Insoles will default to the No Heat setting. Note: If no specific heat
setting is selected, the Insoles do not generate heat and use minimal battery power.
2. Select a setting on the Remote by using the buttons indicating: High, Medium or No
Heat. The LEDs on the back of each insole will flash in different patterns depending
on the heat level selected. On No Heat they will flash one time every several seconds,
on Medium they will flash two times every several seconds, and on High they will
flash three times every several seconds.
ThermaCELL
™
Heated Insoles Instructions
2–E