SDS

SAFETY DATA SHEET
SDS US Creation date: 3-1-2018 Revision date: 6-14-2019
7
ERG Code 115
IMDG Not subject to the provisions of this Code per special provision, SP 191.
Receptacle with a capacity not exceeding 50 mL containing only non-toxic
constituents.
________________________________________________________
15. Regulatory information
US federal regulations This product is a "Hazardous Chemical" as defined by the OSHA Hazard
Communication Standard, 29 CFR 1910.1200.
CERCLA Hazardous Substance List (40 CFR 302.4) Not listed.
SARA 304 Emergency release notification Not regulated.
Superfund Amendments and Reauthorization Act of 1986 (SARA)
Hazard categories Immediate Hazard - No
Delayed Hazard - No
Fire Hazard - Yes
Pressure Hazard - Yes
Reactivity Hazard - No
SARA 302 Extremely hazardous substance Not listed.
SARA 311/312 Yes
Hazardous chemical SARA 313 (TRI reporting) Not regulated.
Other federal regulations
Clean Air Act (CAA) Section 112 Hazardous Air Not regulated.
Pollutants (HAPs) List
Clean Air Act (CAA) Section 112(r) Not regulated.
Accidental Release Prevention (40 CFR 68.130)
Safe Drinking Water Act (SDWA) Not regulated.
US state regulations California Safe Drinking Water and Toxic Enforcement Act of 1986 (Proposition
65): This material is not known to contain any chemicals currently listed as
carcinogens or reproductive toxins.
International Inventories
Country(s) or region
United States All ingredients are listed or are exempt from listing on the U.S. Toxic Substances
Control Act (TSCA) Chemical Substance Inventory.
Canada All ingredients of this product comply with the New Substances Notification
requirements under the Canadian Environmental Protection Act (CEPA).
________________________________________________________
16. Other information
Issue date 03-01-2018
Revision date 06-14-2019
Disclaimer The information and recommendations in this safety data sheet are, to the best
of our knowledge, accurate as of the date of issue. Nothing herein shall be
deemed to create any warranty, expressed or implied. It is the responsibility of
the user to determine the applicability of this information and the suitability of
the material or product for any particular purpose.