Installation Guide

8
2) Connect the tip over switch. Ensure both wires are firmly attached to metal plugs.
(see figure 3)
Figure 3 – Tip over switch connection
3) Attach regulator to propane tank. (See figure 4)
Figure 4 – Regulator connection
Check for Leaks
Your portable heater has been checked tested at the factory for normal operation. The
user MUST check all gas connections for leaks. This includes the gas
hose/regulator/cylinder. Follow this procedure:
 Make leak solution by mixing 1-part liquid dish soap and 3 parts water.
 Spoon several drops (or use squirt bottle) of the solution onto the gas
hose/regulator and regulator/cylinder connection.
 Inspect the connections and look for bubbles.
 If no bubbles appear, the connection if safe.
 If bubbles appear, there is leak, loosen and re-tighter this connection.
Disconnect Cylinder When Storing or Transporting
VERIFY THE FOLLOWING PRIOR TO STORING OR TRANSPORTING THE HEATER
 Turn off the heater by turning the control valve to the right to the off position.
 Turn off the valve of the LP cylinder.
 Loosen the screw of cylinder and regulator.
 Disconnect the cylinder from regulator.