Installation Guide

7
WARNING: A qualified service person must install heater. Follow all local codes.
 You must provide propane gas and propane cylinder. Use a standard 10lb. or
20lb. propane cylinder.
 Use this heater only with a propane vapor withdrawal supply system. See
chapter 5 of the standard for storage and handling of liquefied petroleum Gas,
ANSI/NFPA58. Your local library or fire department should have this book.
 The minimum permissible gas supply pressure of 11 W.C. is required for purpose
of input adjustment.
 The minimum hourly of 15,000BTU is required input rating for a heater for
automatic operation at ratings less than full input rating.
 The pressure regulator and hose assembly supplied with the appliance must be
used.
 The installation must conform with local codes, or in the absence of local codes,
with National Fuel Gas Code, ANSI Z223.1.
 A dented, rusted or damaged propane cylinder may be hazardous and should be
checked by your cylinder supplier. Never use a propane cylinder with a damaged
valve connection.
 The propane cylinder must be constructed and marked in accordance with the
specifications for LP gas cylinders of the U.S. Department of Transportation
(DOT).
 Never connect an unregulated propane cylinder to the heater.
1) Mount the heater to the bracket using the screws provided. (see figure 2). Some
models come pre-mounted and require no attention to assembly.
Figure 2 – Mounting heater to bracket