Installation Guide

3
 The installation of fixed appliances shall only be carried out only by competent
persons and be in accordance with the relevant Codes of Practice.
WARNING:
This appliance requires a gas hose and regulator. User MUST use hose and
regulator provided with heater or a replacement hose that is the same as the one
provided with the heater. Regularly check the gas hose and if necessary, replace
the gas hose
DISCONNECT LP tank before moving the heater.
 Do not attempt to alter unit in any manner.
(FOR EXAMPLE: using the heater without the protective grill or heater stand
could cause injury)
 Do not shorten the burner post assembly.
 The appliance shall not be used in basements or below ground level.
 Heater must always be placed on a solid and level surface.
 Never store items underneath the heater. These items could be subjected to
radiant heat and seriously damaged.
 Always assure there is ample fresh air ventilation
FOR INDOOR USE ONLY
 Never replace or substitute the regulator with any regulator other than the factory
suggested replacement.
 The heater be installed such that it is not directly exposed to water spray, rain
and/or dripping water
 Do not clean the heater with cleaners that are combustible or corrosive.
 Do not paint burner plaques, control panel or back of the heater.
 All leak tests should be done with a soapy solution. NEVER USE AN OPEN
FLAME TO CHECK FOR LEAKS.
 The LP gas cylinder should be turned off when the heater is not in use.
 Storage of an appliance indoors is permissible only if the cylinder is disconnected
and removed from the appliance.
 A cylinder must be stored outdoors in a well-ventilated area out of the reach of
children. A disconnected cylinder must have dust caps tightly installed and must
not be stored in a building, garage or any other enclosed area.
At least once a year, the unit should be inspected for the presence of spiders,
spider webs or other insects. Check the heater immediately if any of the following
exist:
1. The smell of gas in conjunction with extreme yellow colored tips of the burner
flames.
2. The heater does not reach temperature.
3. The burner makes popping noise during use (a slight popping noise is normal
when the burner is extinguished after using).