Warranty

Lighting

1) STOP! Read the safety information on the inside of the heater. User MUST follow

these lighting procedures or the heater will NOT operate properly.

2) Make sure equipment shutoff valve is fully open.

3) Turn control knob clockwise to the OFF position.

4) Wait five (5) minutes to clear out any gas. Then smell for gas, including near the

floor. If you smell gas, STOP! Do not try to light any appliance. Do not touch

electrical switch or use any phone in the building. Immediately contact gas

supplier from a neighbor’s phone. Follow gas supplier’s instructions. If you can’t

reach the gas supplier, call the fire dept. If you don’t smell gas, go to the next

step.

5) Turn control knob counterclockwise to the START position. Press in control knob

for five (5) seconds and simultaneously press the igniter button. This will light the

pilot. The user must verify the pilot is lit prior to turning the knob to the first flame

position. In the event the pilot is not lit you must wait 5 minutes to relight.

6) Turn control knob to single flame symbol. This will light the bottom 3 ceramic

plaques.

7) Turn the knob again to the double burner symbol and this will light the upper 3

ceramic plaques. (it is best to allow the bottom 3 plaques to warm up first prior to

turning the top plaques on.)

Shut down

1) Turn control knob clockwise to START (normally, burner will make a slight

popping sound when extinguished.)

2) To extinguish pilot, depress control knob and continue to turn it clockwise to

OFF.

3) Turn cylinder valve clockwise to OFF and disconnect regulator when heater is

not in use.

After operation check:

1) Gas control is in OFF position.

2) Gas Tank valve is OFF.

3) Disconnect gas hose by unscrewing the plastic end attached to the cylinder.

4) Heater is upright in a secure location.

5) Storage of an appliance indoors is permissible only if the cylinder is disconnected

and removed from the appliance.

6) A cylinder must be stored outdoors in a well-ventilated area out of the reach of

children

7) A disconnected cylinder must have dust caps tightly installed and must not be

stored in a building, garage or any other enclosed area.