Operating Guide

1. Open equipment shutoff valve.

2. Open gas supply tank valve.

3. Make sure control knob of heater is in the OFF position.

4. Check all joints from equipment shutoff valve to control valve. Apply mixture of liquid soap and water to

gas joints. If bubbles form, there may be a leak.

5. Correct all leaks at once.

UNIT OPERATION

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing

property damage, personal injury or loss of life.

1. When lighting the pilot, follow these instructions exactly.

2. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor

because some gas is heavier than air and will settle on the floor.

3. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in

or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Forced or

attempted repair may result in a fire or explosion.

4. Do not use this appliance if any part has been under water. Immediately call a qualified service

technician to inspect the appliance and to replace any part of the control system and any gas control

which has been under water.

WHAT TO DO IF YOU SMELL GAS

 Open the window or door immediately.

 Do not try to light any appliance.

 Do not touch any electric switch, do not use any phone in your building.

 Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

 If you cannot reach your gas supplier, call the fire department.

Thermoelectric Generating System, USB 2.0 Micro Port & Re-Chargeable 15400 Batteries

Two re-chargeable 15400 batteries are included to start the heater. After the heater is running, the

uniquely equipped thermoelectric generating system will power the complete unit, as well as recharge the

batteries if necessary. Furthermore, you will notice an input port on the front of the unit for a USB 2.0

micro port. In case the log set batteries run out of power, you can connect the attached cord with your

smart phone adapter and plug in to a wall socket, then the unit will operate normally.

LIGHTING INSTRUCTIONS

Before Lighting:

1. Make sure the heater is properly installed and connected. Open the external safety shut off valve (not

part of the heater) on gas inlet line to the heater.

2. Wait five (5) minutes to clear out air inside gas lines. Smell if there is any leakage.

IMPORTANT: If you smell any gas, do not try to light any appliances, do not touch electrical