Operating Guide

16
Remote Control
Thermablaster Remote log sets come with a wireless remote control that is synchronized with the log set
at the factory. This remote has an onboard thermostat that senses the temperature at the location of the
remote. Please consider the location when mounting the remote as this will determine how much heat is
put into the room. The remote can be used adjust the target temperature, gauge current
temperature and turn the log set completely off. For best performance, we recommend that the remote
has a direct line of sight with the log set and is positioned within 10 feet. Please note for safety reasons
you cannot start the log set from the remote. Initial lighting of the logs must be done at the front of the unit.
Once lit the logs will cycle between pilot and burner by using the remote control.
Remote Operation
o Power (Set): Function allows you to only shut off the whole system when depressed
o Clock: Will set the time on the remote control
1. Depress clock button until time is blinking.
2. Use Up (˄) and Down (˅) arrows to set time on the remote control
3. Once hours are set, press the clock button and the minutes field will appear as blinking. Use
the arrows to adjust minutes.
Note: When desired time is set, no further action is necessary
o Up (˄) and Down (˅): These buttons will allow you to set the heat to your desired temperature.
You can also turn on and off the main burner by adjusting temperature.
o Remote control distance: 10m (393.7in).
Set to ℃ or ℉:
 ℃ refers to Centigrade. ℉ refers to Fahrenheit.
 Set the remote control to OFF (the screen will show OFF).
 Press Up (˄) and Down (˅) simultaneously. When the
temperature icon flashes, press Up (˄) or Down (˅) to choose
the temperature unit. The setting will be saved and exit
automatically after a short time, or you can exit immediately
by pressing Clock.
 Default setting: ℉
Power (set) Clock Temp. Up(^) Temp. Down(˅)
Remote Control Synchronization