Owner's Manual Dehumidifier HI-E Dry Vehere

4
www.thermastor.com • [e-mail]-Free 1-800-533-7533
3.1D In Remote Area, Duct Inlet & Outlet
It is often desirable, to install the Vehere in an adjacent
equipment room or unfinished area. Air is then transferred
between the humid room and the unit via ducting.
Remotely mount the Vehere humidity control in the humid
room and wire to the Vehere. Local electrical codes must
be followed when wiring the control. Refer to the “Mounting
the Humidity Sensor/Controller” section which follows.
(See Fig. 5)
3.1C In Humid Area, Duct Inlet and/or Outlet
If the pool room is very large or has high ceilings,
dehumidification can be improved by adding an inlet
and/or outlet duct to circulate and destratify stagnant
areas. Add inlet or outlet ducting to create flow across the
area’s greatest length. For areas with ceilings higher than
12’, use an inlet duct to draw warm, moist air from near
the ceiling. See section 4.5 for attaching duct collars &
ducting. (See Fig. 4)
Dehumidistats
for Quiet-Vent and
remote Vehere
Direct Warm & Dry Air
Toward Window Glass
Quiet-V
ent
Optional Quiet-Vent
Exhaust Ventilator
Low = 165 CFM
high = 290 CFM
Vehere Pool & Spa
Humidity Controller
Figure 4: Installation in humid area with ducting.
Quiet-V
ent
Dehumidistats
for Quiet-Vent and
remote Vehere
Direct Warm & Dry Air
Toward Window Glass
Optional Quiet-Vent
Exhaust Ventilator
Low = 165 CFM
high = 290 CFM
Vehere Pool & Spa
Humidity Controller
Figure 5: Installation in remote area with ducting.