User Manual

Theia lens motor controller instructions
Theia Technologies® motor control
v.180628
1. Connect USB cable between the lens control board and computer with Windows 7/10
2. Open the "Device Manager"
3. Expand "Universal Serial Bus controllers" and open "USB Serial Converter"
4. In "Advanced" tab, check "Load VCP" (Checkbox must be checked)
5. Click “OK” to save the settings
6. Disconnect the USB cable then reconnect the USB cable.
7. Expand "Ports (COM & LPT)" and open "USB Serial Port (COMx)"
The COM port for your controller board may have a different number. If the COM port is
greater than 9 continue with the following steps.
8. In "Port Settings" tab, chose "Advanced .."
9. Set the COM Port below or equal COM9