User`s manual

46
Display Mode
During normal operation, the LCD will be in Display Mode.
Display Mode
Item
Description
Host Name
Current host name of the system.
WAN/LAN1
Current WAN/LAN1 IP setting.
LAN2
Current LAN2 IP setting.
Link Aggregation
Current Link Aggregation status
System Fan1
Current system fan1 status.
System Fan2
Current system fan2 status.
CPU Fan
Current CPU fan status
2009/05/22 12:00
Current system time.
Disk Info
Current status of disk slot has been installed
RAID
Current RAID status.
The Thecus IP storage will rotate these messages every one-two seconds on the
LCD display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the Thecus IP storage by press button. To use USB
copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front end.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display “USB Copy?”
4. Press Enter () and the Thecus IP storage will start copying USB disks
connected to the front USB port.
5. All of data will be copied into system folder named “USB copy”.
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter () and an “Enter Password” prompt
will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is “ 0000 ”. If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
Description
WAN/LAN1 Setting
IP address and netmask of your WAN/LAN1 ports.
LAN2 Setting
IP address and netmask of your LAN2 ports.
Link Agg. Setting
Select Load Balance, 802.3ad or Failover.
Change Admin Passwd
Change administrator’s password for LCD operation.
Reset to Default
Reset system to factory defaults.
Exit
Exit Management Mode and return to Display Mode.