User`s manual

Chapter 3: First Time Setup

Overview

Once the hardware is installed, physically connected to your network, and powered

on, you can configure the Thecus IP storage so that it is accessible to your network

users. There are two ways to set up your Thecus IP storage: using the Thecus

Setup Wizard or the LCD display. Follow the steps below for initial software

setup.

Thecus Setup Wizard

The handy Thecus Setup Wizard makes configuring Thecus IP storage a snap. To

configure the Thecus IP storage using the Setup Wizard, perform the following

steps:

1. Insert the installation CD into your CD-ROM drive (the host PC must be

connected to the network).

2. The Setup Wizard should launch automatically. If not, please browse your

CD-ROM drive and double click on Setup.exe.

3. The Setup Wizard will start and automatically detect all Thecus storage

devices on your network. If none are found, please check your connection

and refer to Chapter 7: Troubleshooting for assistance.

4. Select the Thecus IP storage that you like to configure.

5. Login with the administrator account and password. The default account

and password are both “admin”.

NOTE

For MAC OS X users, double click on Thecus Setup Wizard .dmg file.