User`s manual

49
Chapter 3: System Administration
Press YES. All data in the volume will be removed.2.
iSCSI Thin-Provisioning•
If iSCSI Thin-Provisioning is selected when creating an iSCSI target volume, virtual memory is as- iSCSI target volume, virtual memory is as- virtual memory is as-
signed to the target, allowing the physical memory to reach maximum capacity and adding new
disks only when needed.
To setup iSCSI thin-provisioning, simply select “Thin-Provision” mode from the “Create LUN” setting
screen.
Next, allocate capacity for the iSCSI thin-provision volume by dragging the Allocation bar to the de-the iSCSI thin-provision volume by dragging the Allocation bar to the de-iSCSI thin-provision volume by dragging the Allocation bar to the de-ging the Allocation bar to the de- the Allocation bar to the de-Allocation bar to the de-bar to the de-the de-
sired size.
After the size has been determined, click OK to confirm. Now you will see the iSCSI thin-provisioning
volume is available from the list. Please refer to the screenshot below.
If creating an iSCSI target volume under “Instant Allocation”, physical memory is assign to the target,
being limited by the available memory. For the iSCSI target volume created under “thin-provisioni n g”,
virtual memory is assigned to the volume, which can go up to 16384GB (16TB).
LUN ACL•
After iSCSI target has been created, you are one step away from using the iSCSI volume. Under “LUN
ACL”, you need to add “Initiator iqn” and setup ACL access privileges to determine the accessibility.
Please refer the screen shot below for where “Initiator iqn” can be found.