User`s manual
28
Chapter 3: System Administration
Specify a RAID ID. 3.
If this RAID volume is meant to be the Master RAID volume, tick the Master RAID checkbox.4.
In a multiple RAID conguration, one RAID volume must be designated
as the Master RAID volume. The Master RAID volume will store all
installed modules. If the Master RAID is changed to another location
(i.e. assigning volume 2 to be the Master RAID volume after volume 1
had been previously assigned), then all modules must be reinstalled.
In addition, all system folders that were contained on the Master RAID
volume will be invisible. Reassigning this volume to be the Master RAID
will make these folders visible again.
Selected whether the RAID volume will be encrypted or not. 5.
The RAID volume can protect data by using RAID Volume Encryption function to prevent
the risk of data exposure. To activate this function, the Encryption option needs to be en-data exposure. To activate this function, the Encryption option needs to be en-activate this function, the Encryption option needs to be en- this function, the Encryption option needs to be en-the Encryption option needs to be en- Encryption option needs to be en-needs to be en-
abled while the RAID is created and followed by a password input for identification. Also,
an external writable USB disk plugged into any USB port on the system is required to save
the password you have entered while the RAID volume is being created. See the screenshot
below for details.