User`s manual

17
Chapter 3: System Administration
Time: Setting system time 3.3.7
From the System Management category, choose the Time item and the Time screen appears. Set the
desired Date, Time, and Time Zone. You can also elect to synchronize the system time on Thecus IP
storage with an NTP (Network Time Protocol) Server.
See the following table for a detailed description of each item:
Time
Item Description
Date Sets the system date.
Time Sets the system time.
Time Zone Sets the system time zone.
NTP Service Select Enable to synchronize with the NTP server.
Select Disable to close the NTP server synchronization.
Sync with external NTP
Server
Select YES to allow Thecus IP storage to synchronize with an NTP server of your choice. Press Apply
to change.
Notication conguration3.3.8
From the System Management category, choose the Notifi cation item, and the Notifi cation Confi gu-System Management category, choose the Notifi cation item, and the Notifi cation Confi gu-, choose the Notification item, and the Notification Configu-
ration screen appears. This screen lets you have Thecus IP storage notify you in case of any system
malfunction. Press Apply to confirm all settings. See following table for a detailed description of each
item.
Notication Conguration
Item Description
Beep Notification Enable or disable the system buzzer that beeps when a problem occurs.
Email Notification Enable or disable email notifications of system problems.
Authentication Type Select the SMTP Server account authentication type.
SMTP Server Specifies the hostname/IP address of the SMTP server.
Port Specifies the port to send outgoing notification emails.
SMTP Account ID Set the SMTP Server Email account ID.
Account Password Enter a new password.
Log Level Select the log level to send the e-mail out.
Sender’s E-mail Address Set senders email address to send email notifications.
Receiver’s E-mail Address
(1,2,3,4)
Add one or more recipient’s email addresses to receive email notifications.