User`s manual

178
See the following table for a detailed description of each item.
UPS Setting
Item Description
UPS Monitoring Enable or disable UPS monitoring.
Remote UPS Monitoring Enable or disable Remote UPS monitoring.
Remote UPS IP Input the IP address of your network UPS.
Manufacturer Choose the UPS manufacturer from the dropdowns.
Model Choose the UPS model number from the
dropdowns.
Battery Status Current status of the UPS battery
Power Current status of the power being supplied to the
UPS
Seconds between power failure and
first notification
Delay between power failure and first notification in
seconds.
Seconds between subsequent power
failure notifications
Delay between subsequent notifications in seconds.
Shutdown the system when the
battery charge is less than
Amount of UPS battery remaining before system
should auto-shutdown.
Apply Press Apply to save your changes.
Link Aggregation mode description
Field Description
Load Balance
(Balance-rr)
(Round-Robin)
Round-robin policy: Transmit packets in sequential order from the first
available slave through the last. This mode provides load balancing
and fault tolerance.
Failover
(Active-Backup)
Active-backup policy: Only one slave in the bond is active. A different
slave becomes active if, and only if, the active slave fails. The bond's
MAC address is externally visible on only one port (network adapter)
to avoid confusing the switch. This mode provides fault tolerance. The
primary option affects the behavior of this mode.