User`s manual

• To use the Link Aggregation with “802.3ad selected” feature,
please make sure the networking equipment on the other end of
Ethernet cable also supports 802.3ad protocol.
• A correct DNS setting is vital to networks services, such as SMTP
and NTP.
• If you are only using the WAN port, we suggest that you disable IP
Sharing Mode. This will result in higher throughput.
• Enabling DHCP automatically turns on UPnP—see the Service
Support Screen.
• Only use Jumbo Frame settings when operating in a Gigabit
environment where all other clients have Jumbo Frame Setting
enabled.
NOTE
LAN Configuration
The N4100PRO supports two Gigabit
Ethernet ports for higher service availability.
To configure these ports, choose LAN from
the Network menu, and the LAN
Configuration screen appears. Press Apply
to save your changes.
LAN Configuration
Item Description
MAC Address Displays the MAC address of the LAN interface.
IP Specifies the IP address of the LAN interface.
Netmask Specifies the Network Mask of the LAN interface.
Jumbo Frame Support Enable or disable Jumbo Frame Support on the LAN interface.
DHCP Configuration
A DHCP server can be configured to assign IP addresses to devices connected to
the LAN port. To configure these ports, choose LAN from the Network menu.
DHCP Configuration
Item Description
DHCP Server Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN interface.
Start IP Specifies the starting IP address of the DHCP range.
End IP Specifies the ending IP address of the DHCP range.
DNS Server Displayed the DNS server IP address.
NOTE
The IP address of the LAN interface should not be in the range of the
Start IP address and End IP address.
WARNING
The IP Segment of WAN and LAN should not overlap.
39