User`s manual

Network Management
Use the Network menu to make network configuration settings as well as service
support settings.
WAN Configuration
From the Network menu, choose WAN, and the WAN Configuration screen
appears. This screen displays the network parameters of the WAN connection.
You may change any of these items and press Apply to confirm your settings.
See a description of each item in the following table:
WAN Configuration
Item Description
Host name Host name that identifies the N4100PRO on the network.
Domain name Specifies the domain name of the N4100PRO.
MAC Address MAC address of the network interface.
Jumbo Frame Support Enable or disable Jumbo Frame Support of the WAN interface on
your N4100PRO.
DHCP Enable or disable the N4100PRO from obtaining in IP address via
DHCP server. If you require a static IP, disable this feature and
input your network configuration.
IP IP address of the WAN interface.
Netmask
Network mask, which is generally: 255.255.255.0
Gateway Default Gateway IP address.
DNS Server Domain Name Service (DNS) server IP address.
IP Sharing Mode When enabled, PCs connected to the LAN port will be able to
access the WAN. Default is Enabled.
Link Aggregation Specifies whether WAN and LAN ports will be aggregated and
act as one port.
Failover: When one port fails, the other one will take over.
Load Balance: Ethernet traffic will flow alternative between two
Ethernet ports.
802.3ad: Linkage two Ethernet ports in parallel to increase
throughput.
38