User`s manual

Chapter 3: First Time Setup

Overview

Once the hardware is installed, physically connected to your network, and powered on, you

can configure the N0204 miniNAS so that it is accessible to your network users. Follow the

steps below for initial software setup.

Start Thecus N0204 Setup Wizard

The handy Thecus Setup Wizard makes configuring N0204 miniNAS a snap. To configure the

N0204 miniNAS using the Setup Wizard, perform the following steps:

Setup1. Insert the installation CD

Insert the installation CD into your CD-ROM Drive (the host PC must be connected to the

network). The auto run program should launch automatically. If not, please browse your CD-

ROM drive and select setup wizard.

Setup2. Start the Windows Setup Wizard

It will start and automatically detect all N0204 minNAS storage devices on your network. If

none are found, please check your connection and refer to Chapter 8: Troubleshooting for

assistance.

Setup3. Device Discovery

Select the N0204 miniNAS that you like to configure. Press Next to continue.