Installation Guide
EXCLUSIVE DISTRIBUTOR FOR USA
Tile Doctor
www.TileDoctor.com
877-TileDoc (845-3362)
Made In Italy
Application
Empty completely all the contents of the catalyst (B) onto the paste (A).
Mix at slow speed using an electric drill equipped with mixing paddle (Never
mix only by hand with a trowel). Scrape the walls of the bucket to eliminate all
parts of non-catalysed product.
Apply the product with a notched trowel.
The tiles are laid on the adhesive applying a consistent pressure to ensure contact
with
the adhesive before it’s initial set time which will occur after 50 minutes.
The joints between the tiles may be grouted after about 24 hours.
Mixing ratio: Component A: 92,6 parts by weight - Component B: 7,4 parts by weight.
Mixture life: approx. 60 minutes.
Allowed application temperatures: from +10°C to +30°C (50F to 86F).
Open time: 50 minutes.
Set to light foot traffic and grouting: after approx. 24 hours.
Cleaning of equipment and residue: with water prior to hardening.
Consumption: 1.1/3.5 kg/m
2
(.22 lbs to .70 lbs per SF ).
Shelf life: 24 months in original packaging in a dry place. AVOID FREEZING.
1 - Apply product with a notched trowel of at least 2mm, smooth
product with a at trowel to a insure a consistent layer of 1mm
minimum thickness of waterproong, now apply the required
adhesive for the tile being bonded to the waterproong layer with
an appropriate sized notched trowel (being careful not to break
through to the 1mm layer) and bond your tiles.
WATERPROOFING OF SURFACES AND GLUEING
To obtain the simultaneous waterproofing of the surface, you can proceed in two ways:
2 - Create a levelling of at least 1 mm of thickness. When the product
is walkable (approx. 24 hours), then glue the ceramic tiles using a
notched trowel.
Litoelastic EVO