SDS

Page 3/6
Safety data sheet
according to 1907/2006/EC (REACH)
Printing date 25.11.2014 Revision: 25.11.2014Rev. 1
(Contd. of page 2)
39.4.1
See Section 13 for disposal information.
SECTION 7: Handling and storage
·
7.1 Precautions for safe handling No special precautions are necessary if used correctly.
·
Information about fire - and explosion protection: No special measures required.
·
7.2 Conditions for safe storage, including any incompatibilities
·
Storage:
·
Requirements to be met by storerooms and receptacles: No special requirements.
·
Information about storage in one common storage facility: Not required.
·
Further information about storage conditions: None.
·
7.3 Specific end use(s) No further relevant information available.
SECTION 8: Exposure controls/personal protection
·
Additional information about design of technical facilities: No further data; see item 7.
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
112-57-2 3,6,9-triazaundecamethylenediamine
WEEL (USA) Long-term value: 5 mg/m³
Skin; DSEN
·
Additional information: The lists valid during the making were used as basis.
·
8.2 Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures: Wash hands before breaks and at the end of work.
·
Respiratory protection: Not required.
·
Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the
preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has therefore to be
checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to
be observed.
·
Eye protection: Not required.
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Appearance:
·
Form: Solid
·
Colour: According to product specification
·
Odour: Characteristic
·
Odour threshold: Not determined.
·
pH-value: Not applicable.
·
Change in condition
·
Melting point/Melting range: Undetermined.
·
Boiling point/Boiling range: 200 °C
·
Flash point: 130 °C
·
Flammability (solid, gaseous): Not determined.
·
Ignition temperature:
·
Decomposition temperature: Not determined.
(Contd. on page 4)
GB
Trade name: EPOXYSTUC X 90 (COMP B)