User manual

13 [PEAK]
This LED lights up on overload in channel 1. If this happens, turn the [GAIN] control counterclockwise until the LED goes
out.
14 [HIGH - LOW - PAN]
Tone and pan control for channel ‘CH1’ . Slide the ‘HIGH’ control up or down to raise or lower the treble. Slide the ‘LOW’
control up or down to raise or lower the bass. Slide the ‘PAN’ control up or down to move the signal source further to the
left or right in the stereo panorama.
15 [HIGH - LOW - PAN]
Tone and pan control for channel ‘CH2’ . Slide the ‘HIGH’ control up or down to raise or lower the treble. Slide the ‘LOW’
control up or down to raise or lower the bass. Slide the ‘PAN’ control up or down to move the signal source further to the
left or right in the stereo panorama.
16 [GAIN]
Control to adjust the sensitivity of the input ‘CH1’ .
17 [GAIN]
Switch for selecting the sensitivity of input ‘CH2’ between LOW (switch pressed = low sensitivity) and HIGH (switch not
pressed = high sensitivity).
Connections and controls
mixer
16