User manual

7 [MONITOR]
Volume control for the Monitor output.
8 [L - CLIP - R]
The ‘L’ or ‘R’ LED lights up green when a signal is present in the respective bus side. It lights up red when overload occurs
in the respective bus side. Then lower the input levels that possibly cause the overload or turn the ‘MAIN MIX’ control
counterclockwise.
9 [PEAK]
This LED lights up on overload in channel 2. If this happens, turn the [GAIN] switch to the LOW position.
10 [MAIN MIX]
Volume control for the ‘MAIN MIX’ output and the USB port.
11 [CH 2]
Level control for the signals at input ‘CH2’ .
12 [CH1]
Level control for the signals at input ‘CH1’ .
Connections and controls
MicroMix 1 USB
15