Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 445818_11.11.2020
EN
Quick Start Guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the manual
for future reference. If you pass the product on to others please include this manual.
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
MicScreen Desktop
The plasticiser contained in the rubber feet of this product may possibly react with the
coating of your parquet, linoleum, laminate or PVC oor and after some time cause
permanent dark stains. In case of doubt, do not put the rubber feet directly on the
oor, but use felt-pad oor protectors or a carpet.
Safety instructions
Intended use
This device is used to shield unwanted noise and room acoustics from microphone
recordings. Any other use or use under other operating conditions is considered to
be improper and may result in personal injury or property damage. No liability will
be assumed for damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts from the product. They could
swallow the pieces and choke!
Where to use the product
Never use the product
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
General handling
• To prevent damage, never use force when handling the product.
• Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use
liquid cleaners such as benzene, thinners or ammable cleaning agents.
Set-up
1) First make sure the scope of delivery is complete:
A) Microphone screen (310 ×230mm)
B) Handscrew for screen
C) Support arm for the screen
D) Mic support arm
E) Sliding assembly
F) Base plate (222 ×234mm)
G) End cap
2) Screw the support arm for the screen (C)
onto the base plate (F).
3) Hang the sliding assembly (E) onto the
upper thread of the support arm (C)
and x it by screwing the handscrew for
screen (B) onto the thread on top of the
support arm (C).
4) Place the microphone screen (A) onto the hand
screw (B).
5) Remove the end cap (G) from the mic support arm (D). Then
insert the support arm (D) into the sliding assembly (E).
6) Then, screw the end cap back into the lower thread on
the mic support arm (D) to hold the support arm in the
sliding assembly.
7) Attach the microphone holder to the upper thread of the
mic support arm (D).
8) The microphone screen can also be mounted on a
studio boom instead of on the base plate. The assem-
bly is no dierent, only mic screen and microphone
are then positioned inverted.
Adjustment
1) Loosen the handscrew of the sliding assembly (E), then move the microphone
on the mic support arm (D) horizontally toward or away from the screen.
2) Loosen the thumbscrew on the mic support arm (D), then adjust the height
of the microphone as desired. Then re-tighten the hand screw to hold the
microphone in place.
3) Loosen the hand screw on the support arm for the screen (C), then adjust the
position of the screen together with the microphone in height as desired.
Then, tighten the hand screw to hold the screen and microphone in place.
Handscrew
Handscrew
Handscrew