User manual
Table Of Contents
6 Operating
6.1 Setting up the transmitter
Use the or buttons or to increase or decrease the indicated value until the desired value is
displayed.
Transmitter and receiver must be set to the same channel.
Use the switch MONO/STEREO on the rear panel to toggle between mono and stereo opera-
tion.
The transmitter displays the levels of the left and right channel in an LED chain. Set the con-
trols for the input sensitivity so that the bar is used up to the value ‘0’, but without exceeding
this value.
Channel selection
Selecting the operating mode
Adjusting input level
Operating
UHF wireless system
24