User manual

You can connect a foot switch (not supplied) to the two-pole [FOOT SW] socket (12) to turn the
internal reverb function on or o.
Insert the plug of the mains cable (18) into an earthed mains wall outlet.
When all connections have been established, turn on the device using the main switch (9). The
power LED (10) lights up.
You can adjust the volume of the individual signals with the [VOLUME] controls (5) in each
channel. The overall volume is set by the [VOLUME] control (17) in the master section.
Turn the [TONE] control (1) to shape the sound of the individual signals in each channel. There
is an additional 3-band EQ with [LOW] (6), [MID] (7) and [HIGH] (8) controls for the overall signal
in the master section.
You can set the reverb level for each channel separately with the [REVERB] controls (2). The
overall reverb level can be adjusted using the [REVERB] control (16) in the master section.
Use the [TAPE] control (11) to adjust the playback volume of the device connected to the
[TAPE PLAY] sockets (20).
Turning on
Adjusting sound and volume
Operation
powermixer
26