User manual

5 IEC chassis plug with fuse holder
6 [ON] [OFF] [STANDBY]
On / o switch for standby function. If the standby function is enabled, the device automatically switches to standby
mode after fteen minutes without any input signal.
7, 8 [OUTPUT]
Output channel B, A
n Speaker Twist chassis connector for speaker output (1+, 2+: positive; 1–, 2–: negative)
n Screw terminals
9 [GROUND] [LIFT]
Ground / lift switch. If hum is caused by a ground loop, you can use this switch to disconnect the connection
between the earth pin of the device and the signal ground of the device.
10 [LIMITER]
Limits the output level so that the maximum distortion is 5%.
Connections and operating elements
power amplier
22