Installation & Assembly

Slide the medium decorative nut (H) followed by the plastic

slip joint washer (Z5) to the bottom end of the 47" stainless steel tube and

loosely attach to the receiving thread of the conversion panel (E). (Fig 5)

Install the nipple (P) to the water fitting from the wall. Slide in

the flange (Q) onto the nipple (P) and install the shut off valve (N). (Fig 7)

Turn on the shut off valve and fill the tank to its waterline and

test flush system,checking for leaks. (Water level is preadjusted from

the factory; in some instance re-adjustment might be necessary.

Caution: Before turning on the water, please make sure that all

parts are installed properly. Never use abrasives, detergents or

acids to clean the unit. Use only mild soap and water with a soft

cloth to clean the set, the use of harsh chemicals and abrasives of

any kind will damage the set which will not be covered by the

warranty.

Note: Steps 6 & 7 involves slight pulls and pushes of the 47"

stainless steel tube that will enable proper fitting of the 47"

stainless steel tube (G), then check final alignment of the tube

and tighten all joints.

Note: Please wrap both sides of the nipples with thread sealer.

Slide brass slip joint nut (Z6) followed by plastic slip joint

washer (Z5) and large decorative nut (J) with rubber washer (K) into

top end of the 47" stainless steel tube (G), Insert rubber water restrictor

(Z7) inside the 47" stainless steel tube (G) and loosely attach the

large decorative nut (J) to the receiving thread of the flush valve (A2)

on the woodtank slightly tighten all joints. (Fig 6)

47" Tube (G)

These instructions and drawings disclose confidential and other data of proprietary

nature owned by Renovator's Supply, Inc. and may not be used or disclosed to

others without the prior consent of Renovator's Supply, Inc.

Slide the small brass decorative nut (V) from the opposite

end of the 1/2" water supply line (L) (non collared end), and insert cone

washer (W) in between the 1/2" water supply line (L) and the small brass

decorative nut (V) on the collared end. Connect the small brass decorative

nut (V) to the fill valve receiving thread and hand tighten, connect 1/2" water

supply line (L) and 12" supply line (O) using the compression coupling (M),

then remove the nut and brass sleeve from the shut off valve (N), align the

12" supply line (O) to the shut off valve (N) measure appropriate length and

trim accordingly. Slide the brass nut followed by the brass sleeve removed

from the shut off valve earlier onto the 12" supply a wrench and make sure

all connections are squarely aligned to assure no leakage. Do a final check

that all connections are tightened. (Fig 8)

Fasten conversion panel (E). Place cover plate (F) on top of

conversion panel (E) and secure with cover plate screws (T4). (Fig 5)

ZpipeRev052010