Installation & Assembly

First install the toilet bowl as per manufacturers’

specifications and instructions.

Attach flush arm (A) on the brass cradle (X) mounted on the

right side of the wood tank (A7). Hook the end of the pull chain (C)

to the flush arm and flapper chain to the opposite side. (Fig 1)

Make sure and check that the refill tube (A5) is inserted on

top of the overflow pipe. (Fig 2)

To mount molding bracket (D), locate the centerline on the

wall behind the bowl and mark tank height. We recommend that

the bottom edge of the molding be about 60 inches from the

floor for regular toilet bowl height 14.5 inches. Secure molding

bracket to studs with mounting screws (T2), if studs cannot be

accessed we recommend cross studs be toe-nailed into the vertical

studs, use plastic anchors (Z4) for the bottom part of the molding

bracket mark sure to drill within 1 inch of the outside perimeter of

the molding bracket (D). This area will be exposed. (Fig 4)

Align hanger brackets (B) on the wood tank to the inside

notch of the molding bracket (D) and hang the wood tank (A7).

(Fig 3B)

These instructions and drawings disclose confidential and other data of proprietary

nature owned by Renovator's Supply, Inc. and may not be used or disclosed to

others without the prior consent of Renovator's Supply, Inc.

ZpipeRev052010