Specification

RAQ IN A BOX
Universal 2 / 1 RAQ Solar Panel
Racking System
RB-2001
UPC: 00861151002677
Universal Roof Mount Racking Product Description
The RB-2001 1-RAQ is UL rated 2703 structural & electrical holding one solar panel in portrait or landscape
position. It is self-
aligning, self
-
squaring, and designed to be installed quickly. The RAQ technology has” vastly
reduced installation times” by a proven factor of 76%
(NREL). A patented mounting system that unfolds from a
compact shipping state. Providing pre-positioned anchoring
hardware and
universal mounts to the majority of 60 or 72 cell Solar Panels, on the market today.
Up to 18, 1 Panel RAQ’s can be connected in a single row using only 1 grounding point per rail. Designed for rafter spacing of 12”, 16”, 24”
without modifications the 1 Panel RAQ is rated for 190 mph winds and 120lbs snow loads with roof anchors at 24” using lag bolts in
portrait position.
Deck Screw Mounting in Portrait Position Standard
Four anchors of the racking are preset at 48” spacing , they can be adjusted to 12”,16”, 24”, 48”, 72” even 96” spans.
Four anchors rotated 45 degrees can be exchanged to provide landscape mounting of panels but will only mount with Deck
Screws. RAQ’s can be connected with no additional parts forming continuous rows of panels.
Structural Joints
All joining
connections points are UL rated for structural, mechanical and electrical; allowing anchor location adjustments in the field.
Integrated Grounding
All connection points are UL rated for grounding. Only one grounding point for each rail on the stand- alone unit or on a single row is
needed. Grounding lugs are provided with the Power PaQ 2400. The grounding lug will also enable you to ground to any additional rows,
using a 10-gauge copper wire; which will ground the entire unit. When using an inverter that requires grounding please follow
manufactures suggestions. A stainless steel "Type 23" self-tapping bolt is provided to mount Microinverters to the RAQ.
Vertical Adjustable Anchor Points
Each anchor of the racking is adjustable in height 1.5” to its connection to the rail to allow for variances in levels of the roof. This allows the
installation of a flat array accounting for condition of roof surface
Lag Bolt Option
Lag bolts Not Provided: Recommended 5/16 x 4.5”
18-8,
Stainless Steel
100-
--
125,000 psi nominal
While the anchors of the racking are preset at 24" rafter spacing in portrait, they can be adjusted to 12”,16” and 24”, spacing. Each
connection point of anchor to rail allows a 3" tolerance for rafter misalignment. In the event of a misaligned rafter of greater than 3" the
anchor can be removed and a hole can be drilled anywhere in the panel rail with the use of cold-rolled drill bit.
Adjustable panel clamp locations
Mounting position for all the panel clamps, have a 3" range of adjustment for variable width of solar panels. See installation instructions
for details.
Adjustable panel spacers
Each panel clamp is adjustable by rotating it 90 degrees, this spacing between panels to be adjusted to compensate for panel width
changes
Bi - fold type cross brace
The Bi-Fold squaring
arm requires an additional “Type 23” self- tapping bolt which
is provided to secure the unit square
Suggested to use in conjunction with
Solar PaQ-Power PaQ 2400, Ground Mount Conversion, Ballast Mount Conversion
Suggested 3rd party providers of
S5 or common metal roof clamps. Tile roof clamps.