User Manual

Battery Tips:
• Replace batteries when electronic sound begins
to fade or does not work.
• Batteries should be installed and changed under
adult supervision.
• Non-rechargeable batteries are not to be recharged.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy
and disposed properly.
• Supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not use rechargeable batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
LC76325
Battery Change Information:
ATTENTION: Batteries should only be installed/replaced
by an adult.
• Using a Phillips screwdriver remove screw
on the bottom of the vehicle.
• Lift off battery cover.
• Remove old batteries and replace with two
new 1.5 volt AG13 button cell batteries.
• Replace battery cover.
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
099-LC76325 Rev.0
2 x AG 13/LR44
(2 x 1.5V)
099-LC76325 Rev.0 Material: 100 gsm Woodfree Paper
Size: 60mm x 45mm Color:K Date:Sep/04/08 Work by Stella
Front
Back