Instruction Manual

INSTALLATION INSTRUCTIONS FOR 9806- PL
For Post Lamp Fixture
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENTI！COUPER LE COURANT AUNIVEAU DES FUSIBLES OU DU DISJONCTEUR
HANG THE FIXTURE (Fig.1)
1. Place the fixture on the top of the POST on which is to be
mounted and position as desired. Using the holes located
on the POST CAP mark the holes position on the POST.
Remove the fixture from the POST and drill a 1/8” diameter
hole at each marked position on the POST.
2. Pull the power supply wires out from the POST and the
fixture lead wires out from the POST CAP. Connect the
electrical wires as shown in Fig.2 make sure all wire nuts
are secured .You may have to wrap connections with
electrical tape. Attach the POWER SUPPLY GROUND
WIRE to the FIXTURE GROUND WIRE. Using a wire
connector rated for the size of wires being connected.
3. Place the connected wires down inside the POST and
mount the POST CAP in place. Aligning the holes in the
POST CAP with the POST, secure the POST CAP to the
POST using 3 x 1/2” long self Tapping SHEET METAL
SCREWS provided.
4. Install the PL lamp in according with the fixture’s
specification. (1×Max 26W included). (DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!!)
（ NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE）
5. The ballast in each of these models can be replaced by a
qualified electrician without cutting of wires and without
damage to the housing, trim, decorative elements or
carpentry to which the fixture is attached. See installation
steps for more detail. The ballast and lamp are combined,
to replace or install, twist pins into socket as shown on Fig.3
6. Place the glass with narrow side towards the lamp cover
into the fixture. Place the LAMP COVER onto the top of the
lamp compartment.
7. This fixture is rated for a minimum start temperature of -17°
Celsius.
8. This fixture is ETL Listed for Wet Location applications.
Your installation is now complete. Return power to the junction
box and test the fixture.
II366
GLASS
Fig.1
LAMP COVER
WIRE NUT
SCREW
POST CAP
Wire nut
Screw