Installation Sheet

ManualsBrandsThe Great Outdoors ManualsLightingBrixton Ivey 3 Light 28.25" Tall Post Light with Clear Ripple Glass

INSTALLATION INSTRUCTION

For item#9336-270/661 (New. 12/30/2020)

READ AND SAVE THESE INSTRUCTIONS

W AR N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

PREPARING FOR INSTALLATION (Fig. 1)

1. Shut off power at the fuse box or circuit breaker

box and remove the old fixture including the

mounting hardware.

2. Carefully unpack your new fixture and lay out all

the parts in a clear area. Take care not to

misplace any small parts necessary for

installation.

3. Thread finial (A) into all thread (B) on top of

fixture.

CONNECTING THE WIRES (Fig. 2)

4. Pull the black, white and ground wires out of the

post.

5. While carefully supporting the fixture, connect the

electrical wires as shown in Fig. 2. If your post

has a ground wire (green or bare copper),

connect the fixture’s ground wire to it. If not,

consult your electrician for proper grounding.

After wires are connected, tuck them carefully

inside the post.

COMPLETING THE INSTALLATION (Fig. 1)

6. Slide fixture over post and secure with screws

(K).

7. Pull up latch (E) and open the door. Attach crystal

pentalogs (C) into the hole of hanging loops (D).

8. Place candle covers (I) over sockets (J).

9. Install (3) three candelabra base bulbs (F) up to

60 watts each or CFL or LED equivalent (not

included) in accordance with the fixture

specification—DO NOT EXCEED THE

MAXIMUM WATTAGE RATING! (NE PAS

DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!).

10. When replacing front glass (G), pull up latch (E)

and open the door. Lift tabs and remove the

side glass (H) first and then front glass (G). Next

replace front glass (H) and side glass (H). Push

down tabs to secure glass. Relatch (E) the door.

11. For installing or replacing bulbs at a later date,

pull up latch (E) and open the door. (Fig.1).

Your installation is now complete. Return the power

to the outlet box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

LA-3324E

Candle Cover#CCV21048P-270/661