Installation Sheet

INSTALLATION INSTRUCTIONS
Model# 73239-738
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a clear area.
Take care not to misplace any small parts necessary for installation.
3. Thread all thread (L) into finial（K）until snug. Slide gasket (O) over all
thread (L) and insert assembly into top cover (F).
4. Place washer (N) over all thread (L) and tighten with nut (M).
5. Pull black, white and ground wires out of base cup (D).
CONNECTING THE WIRES (Fig. 2)
6. Connect electrical wires while supporting the lantern with wire
connectors (B). If your post (A) (not supplied) has a ground wire (green
or bare copper), connect the fixture ground wire to it. If not, consult your
electrician for proper grounding. After wires are connected, tuck them
carefully inside the base cup (D).
7. Align the base cup (D) with post (A) and secure with mounting screws
(C). (Fig.1)
8. Install (4) four candelabra base bulbs (I) up to 60 Watts, or CFL or LED
equivalent (not included), in accordance with the fixture specification.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING) (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
9. Se Secure cover (F) to fixture frame (H) with screws (E) until tight.
10. This fixture is ETL listed for wet location applications.
Your installation is now complete. Return power to the outlet box and test the
fixture.
BARE COPPER(GROUND)
Fig.2
FIXTURE
WIRES
WHITE
BLACK
(HOT)
WIRES
HOUSE
GREEN OR
WHITE
(NEUTRAL)
WIRES
HOUSE
(GROUND)
COPPER
BARE
FIXTURE
WIRES
BLACK
WIRES
FIXTURE
GREEN OR
HOUSE
WIRES
“CAUTION-RISK OF FIRE CONSULT A QUALIFIED
ELECTRICIAN TO ENSURE CORRECT BRANCH
CIRCUIT CONDUCTOR”
ATTENTION – RISQUE D’INCENDIE, CONSULTER UN
ÉLECTRICIEN QUALIFIÉ POUR VOUS ASSURER QUE LES
CONDUCTEURS DE LA DÉRIVATION SONT ADÉQUATS.
Fig. 1
Candle cover (4) (Part#CCV21079P-861)