Installation Sheet

INSTALLATION INSTRUCTIONS
For Model 72786-66G
WAR N ING ! SH UT P O WE R O F F AT F US E O R CI R C UI T B RE AK E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Shut of power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clean area. Take care not to misplace any small parts
necessary for installation.
3. Separate the roof (E) by loosening two screws (D). Install
(4) four candelabra base bulbs (C) up to 60 watts or CFL
or LED equivalent (not included) in accordance with the
fixture specification. (DO NOT EXCEED THE
SPECIFIED WATTAGE!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!).
4. Re-attached roof (E) and secure with two screws (D).
CONNECTINE THE WIRES (Fig.2)
5. While supporting the fixture, connect the electrical wires
as shown in figure 2. If your post has a ground wire (green
or bare copper), connect the fixture ground wire to it. If
not, consult your electrician for proper grounding. After
the wires are connected, tuck them carefully inside the
post cup (A) (not included).
COMPLETING THE INSTALLATION (Fig. 1)
6. Place the fixture onto post cup (A) and secure with the
three mounting screws (B)
Your installation is now complete. Return power to the
junction box and test the fixture
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(G
round)