Installation Guide

Double Bowl Workstations / Work&WashStations

™

IWS 7D / IWW 7D

IWS 6D / IWW 6D

IWS 5D / IWW 5D

IWS 4D / IWW 4D / IWA 4D

SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE

(Recommendations are based on installing 3 or more Tap accessories)

Galley Tap 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)

Galley Soap Dispenser 1" min hole diameter

Galley Deck Switch 1 3/8" min hole diameter or Galley Automatic Strainer Basket knob 1" min and 1 3/8" max hole diameter

Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)

Center hole diameters 2" behind cutout

Note: Galley Hot and Cold Water dispenser requires a minimum 8" clearance center to center if installed to the right of the Galley Tap

Side view applies to all

Double Bowl Workstations

and Work&WashStations

18” Finished cutout

1/2” Reveal front

and back

10”

16”

Note: For installation where the drain is on the left side, simply reverse placements of Tap and Tap Accessories